EGX-360 Newbie help! Trophy cup handles in the way!

General chat that doesn't fit into other categories
Post Reply
NZBRUCE
Member
Posts: 1
Joined: Sat Jun 01, 2019 11:16 pm
Location: Auckland NZ

EGX-360 Newbie help! Trophy cup handles in the way!

Post by NZBRUCE » Sat Jun 01, 2019 11:34 pm

Hi. I am very new to this. Wife has a dance company and has a lot of trophies so invested in the EGX-360. Still a lot to learn but one issue is, when engraving a trophy, often the handle is just too wide to allow the 360degree turning of the cup. So i end up treating as a flat plate xyz which is not ideal. Is there a way to offset the head form the X0 position? Often i only need about 10mm extra to line up next to handle of the cup... Any help would really be appreciated. Thanks.

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest