Page 1 of 1

EGX-360 Newbie help! Trophy cup handles in the way!

Posted: Sat Jun 01, 2019 11:34 pm
by NZBRUCE
Hi. I am very new to this. Wife has a dance company and has a lot of trophies so invested in the EGX-360. Still a lot to learn but one issue is, when engraving a trophy, often the handle is just too wide to allow the 360degree turning of the cup. So i end up treating as a flat plate xyz which is not ideal. Is there a way to offset the head form the X0 position? Often i only need about 10mm extra to line up next to handle of the cup... Any help would really be appreciated. Thanks.