control software for MDX 650

Post questions, share ideas and techniques relating to 3D prototyping and milling
Post Reply
RolandCTSA
Member
Posts: 2
Joined: Tue Jul 09, 2019 9:11 am

control software for MDX 650

Post by RolandCTSA » Tue Jul 09, 2019 11:19 am

Good day to you.
I have been on your website for the better part of the day.

I am a service provider to the cadcam industry.
I have a client who has a Roland mdx 650 machine. He has had this machine for about twelve years.
1 key change that happened over the past year, is the machine with control software has changed from an HP desktop to a lenova all in one unit. I.e PC and screen 1 piece. Since this happened the roland machine seems to have a buffer problem. Example it is as if the machine has zero look ahead on the nc file. It operates line for line. The current control is serial via RS232.
Now I have attempted the method of installing the printer driver. When doing this the serial link becomes in active.

Thus my key question is still, what control software could i use for file transfer.
Note my file for the the machine is being generated by Artcam.

Please advise: I have obviously attempted consulting with Roland, there answer is Dr engrave, but they do not have an answer to use the generated nc file from artcam.
regards
RolandCTSA

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests