General chat that doesn't fit into other categories
1 post • Page 1 of 1
Hi. I am very new to this. Wife has a dance company and has a lot of trophies so invested in the EGX-360. Still a lot to learn but one issue is, when engraving a trophy, often the handle is just too wide to allow the 360degree turning of the cup. So i end up treating as a flat plate xyz which is not ideal. Is there a way to offset the head form the X0 position? Often i only need about 10mm extra to line up next to handle of the cup... Any help would really be appreciated. Thanks.
Who is online
Users browsing this forum: No registered users and 0 guests